Operator's Guide

Chapter 2 Operating the Library

Using the Control Panel Menus

30 Quantum|ATL 7100 Series Library Operator’s Guide

8 Exit the menu mode.

Setting a Tape

Drive SCSI

Address

The SCSI Address/ Drive function is used to set the SCSI address

of tape drives in the library. The library ships with the tape drives

configured as shown in table 2

Table 2 Default Tape

Drive SCSI Address

To change the SCSI addresses of the drives in the library:

1 Enter the menu mode.

Note: After changing the SCSI address of the library, one of

two things must happen to set the new SCSI ID: the

host controller must issue a “SCSI Bus Reset,” or the

library must be powered off and on again.

SCSI Address Drive Number Physical Location

10 top drive

21 second drive

3 2 third drive

43 fourth drive

5 4 fifth drive

65 sixth drive

1 (second bus) 6 bottom drive

Note:

SCSI address 7 is typically reserved for the host

controller.