Installation Guide

Quantum 1U Rackmount Rail Installation Guide
Document 81-81209-05 A01
January 2006
9
Step 3: Installing the 1U Rackmount into the Equipment Rack0
1 Completely extend the intermediate sections out from the front of the
stationary sections until they lock (see figure 10
).
Figure 10 Extending the
Intermediate Section Rail
—Front View
2 Holding the 1U Rackmount with both hands, position and then slide the
chassis sections into the intermediate sections. When the release buttons
on the chassis sections stop against the intermediate sections, press both
release buttons (on opposite sides) and continue sliding the
1U Rackmount into the rails. See figure 11
.
Figure 11 Sliding the
Chassis Rails into
Intermediate Section
Rail—Front View
Intermediate
Stationary
section
section
Release buttons