Installation Guide

Quantum 1U Rackmount Rail Installation Guide
Document 81-81209-05 A01
January 2006
7
For Racks Deeper
than 24 Inches
0
1 Install both stationary sections onto the front pillars of the equipment
rack, using two screws in the bottom two mounting holes of each
stationary section (see figure 6
). See Typical Rack and Slide
Configurations (For Reference Only) on page 11 for more information.
Figure 6 Attaching the
Front of the Stationary
Section—Front View
2 Attach the two long back brackets to the back pillars of the equipment
rack with two screws in the upper two mounting holes (see figure 7
).
Figure 7 Attaching the
Long Back Bracket—Back
View
Long back bracket