Quick Setup Guide

Access Point Quick Set Up Guide
www.qntmnet.com
Quantum Networks Access Point can be configured in two modes.
• Standalone Mode (Independent management of each Access point) (please go to step 2)
• Cloud Controller mode (Centralized management of Access Points using Quantum Network
cloud) (please go to step 3)
Step 2- Access Point quick configuration in Standalone mode
• Select Management Mode as Standalone and click on Next.
• Admin can select AP operation mode as Bridge or Router.
o Bridge (In this mode, device connects to a wired or wireless router via an Ethernet
cable)
o Router (Gateway) (In this mode, device connects to the internet directly and shares
internet access to multiple wired and wireless devices.
o For Operation Mode - Bridge, select option and follow below procedure.
▪ Configure WLAN (SSID) parameters and click on Next.
▪ Configuration Summary screen will appear. Click on Reconfigure if any
changes required or click on Finish to complete the quick configuration.
o For Operation Mode - Router, select option and follow below procedure.
▪ Configure WLAN (SSID) and Local subnet parameters and click on Next.
▪ Configuration Summary screen will appear. Click on Reconfigure if any
changes required or click on Finish to complete the quick configuration.
Step 3- Access Point quick configuration in Cloud Controller mode
• Select Management Mode as Cloud Controller.
• Enter Cloud controller account credentials (If yet you have not created account on QN cloud,
please refer Step 4). Click on Next.
• Admin can select AP operation mode as Bridge or Router. Select mode and click on Next.
o For Operation Mode - Bridge, select option and follow below procedure.
▪ By selection option Bridge, Configuration Summary screen will appear. Click
on Reconfigure if any changes required or click on Finish to complete the quick
configuration.
o For Operation Mode - Router, select option and follow below procedure.
▪ Configure WLAN (SSID) and Local subnet parameters and click on Next.
▪ Configuration Summary screen will appear. Click on Reconfigure if any
changes required or click on Finish to complete the quick configuration.
Not e : If you do not want to create WLAN (SSID)/LAN now, click on Skip option. It will redirect to
Configuration Summary.