Quick Setup Guide Model: QN-O-230 High Performance 802.11ac (2x2) Wave 2 Outdoor Access Point www.qntmnet.
Access Point Quick Set Up Guide Contents Before You Begin .......................................................................................................................................... 3 Package Contents......................................................................................................................................... 3 Set up Requirements ....................................................................................................................................
Access Point Quick Set Up Guide This Quick Setup Guide provides step-by-step instructions on how to set up Quantum Networks Access Point. After completing the steps described in this Guide, you will be able to install the Access Point (AP) on site and provide wireless network access to users. Before You Begin Your Quantum Networks Access Point can be managed by “Quantum Networks Cloud Controller” or can work in “Standalone” Mode.
Access Point Quick Set Up Guide Step 1- Access Point Initial Configuration • • • Provide internet access to WAN port of the Access Point. Access point default SSID QN_XX: XX will broadcast. (Where XX: XX are last four digits of Access Point MAC Address). Connect QN_XX: XX SSID and browse access point default IP 169.254.1.1. Below screen appears. Figure 1 • • • Click on Start Configuration (Figure1). Do IPv4 setup by selecting required option DHCP, Static or PPPoE and click on Next. (Figure2).
Access Point Quick Set Up Guide Quantum Networks Access Point can be configured in two modes. • • Standalone Mode (Independent management of each Access point) (please go to step 2) Cloud Controller mode (Centralized management of Access Points using Quantum Network cloud) (please go to step 3) Step 2- Access Point quick configuration in Standalone mode • • Select Management Mode as Standalone and click on Next. Admin can select AP operation mode as Bridge or Router.
Access Point Quick Set Up Guide Step 4 – Account setup on Quantum Networks Cloud Controller • • Browse https://cc.qntmnet.com. Click on “Create New Account” to sign up a new account. Figure 4 • • Follow the steps as guided on screen for Registration. Successful registration will show below message. Figure 5 • • Verify QN account from registered email id. Your Account on QNTM Cloud Controller is now ready to use. www.qntmnet.
Access Point Quick Set Up Guide Step 5 – How to Factory Reset AP o o o Power on the AP Push the reset button provided on back panel and hold it for 10 seconds. AP will reset to factory setup. (It will wipe entire AP configuration and store it to factory default setup / Cloud configuration will remain same. ) Access Point Default login detail User Name: Quantum Password: Auto Generated Password will be sent to registered email on Cloud Controller.
Access Point Quick Set Up Guide FCC Statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Access Point Quick Set Up Guide Word of Thanks First of all, thank you for going through the document. We hope, this would have addressed most of your queries. However, we are open for your feedback, suggestions, and feature requests to make this platform more robust to address any vertical, Education, SOHO, Hot-Spots, NGOs, Healthcare, Budget Hotels, Hostels and so on. Feel free to contact us directly on below addresses. Thanking you again! Team Quantum Networks (SG) Pte. Ltd.
