User`s guide

Chapter 2 Installing Internal Tape Drives
Connecting a Power Cable
28 DDS-4/DAT 72 User’s Guide
Connecting a Power Cable 2
To connect a power cable to the internal tape drive:
1 Connect a spare 4-pin power cable from the computer’s internal
power supply to the power connector on the back of the internal tape
drive. Figure 10
shows the location of the power connector on the
internal tape drive.
The recommended 4-pin power connector for the internal drives is an
AMP 1-48024-0 housing, with AMP 60617-1 pins or equivalent.
Figure 10 Power
Connector on the
Internal Tape Drive
Completing Your Installation 2
To complete and test your internal tape drive installation:
1 Use the screws you removed earlier to secure the drive in place.
2 Replace the computer cover.
3 Reconnect the power cord to the computer’s power connector.
4 Turn on the computer. If the internal tape drive is configured to
perform its Power-On Self-Test (see Power-On Self-Test
on page 18),
it performs the test for about five seconds. When the drive passes the
test, all three front-panel LEDs should be
OFF.