User`s guide

Chapter 2 Installing Internal Tape Drives
Mounting the Internal Tape Drive
DDS-4/DAT 72 User’s Guide 23
Mounting the Drive
into a 3.5-inch
Drive Bay
2
The following procedure describes how to mount the drive in a 3.5-inch
drive bay. This procedure assumes your drive is not equipped with side-
mounting brackets.
1 Orient the drive so the front of the drive faces the front of the
computer.
2 Insert the drive into the computer’s drive bay.
3 Align the drive’s front panel with the front panel of the computer.
4 Secure the drive in the mounting bay using two M3.0 metric screws
on each side of the drive (see figure 5
). Figure 6 shows, the 3.5-inch
drive has four screw holes on the bottom and five on each side.
5 Proceed to Connecting a SCSI Cable
.
Figure 5 Mounting an
Internal Tape Drive
Warning: Do not use screws longer than 4 mm; otherwise, you
may damage the drive.