User`s guide

Chapter 2 Installing Internal Tape Drives
Reviewing Drive Default Settings
14 DDS-4/DAT 72 User’s Guide
Figure 3 Internal Tape
Drive Jumper Settings
SCSI interface
compatibility (DDS-4
drives only)
Wide SCSI (LVD
and single ended)
Switches 9
Vendor ID SEAGATE DAT Switch 10
Parameter Default Setting
Jumper Pins/
Switches
Parity enable
Term. power
SCSI ID=7
SCSI ID=6
SCSI ID=5
SCSI ID=4
SCSI ID=3
SCSI ID=2
SCSI ID=1
SCSI ID=0
SCSI ID=15
SCSI ID=14
SCSI ID=13
SCSI ID=12
SCSI ID=11
SCSI ID=10
SCSI ID=9
SCSI ID=8
Default jumper settings shown
(SCSI ID 5, parity checking
enabled and termination
power disabled.
Pins Function
1 - 2 SCSI ID bit 0
3 - 4 SCSI ID bit 1
5 - 6 SCSI ID bit 2
7 - 8 SCSI ID bit 3
9 -10 Parity Checking
11-12 Termination Power