User`s guide

Chapter 1 Introduction and Quick Start Installation
Installing the External Tape Drive
DDS-4/DAT 72 User’s Guide 7
• Terminator Power: Supplied to the SCSI bus
• Data Compression: Enabled
• Media Recognition (DDS-4 drives only): Enabled
• Power-On Self-Test: Enabled
• Host Operating System: Windows 98/Me/XP/NT/2000/2003
Server
• SCSI Interface Compatibility (DDS-4 drives only): Wide SCSI
• Vendor ID: SEAGATE DAT
4 Connect a SCSI interface cable to the drive.
5 Check the SCSI termination.
6 Connect a power cable to the drive.
7 Turn on the computer, turn on the external tape drive, and verify that
the external tape drive is operating properly.
8 Register your tape drive.