Technical data

DAT 72 (DDS Gen5) 36/72 GBYTE
Installing or eplacing a drive in a PRIMERGY server (under LINUX)
Proceed as follows to install or replace a drive in a LINUX server.
i
The following procedure requires you to have root privileges.
Installing a hot-swap drive
Mount the DAT drive and lock it with the handle.
Wait at least 30 seconds.
Add the device to the configuration with the following command:
>> echo scsi add-single-device a b c d > /prog/scsi/scsi [ENTER]
The parameters have the following meaning:
a = Host adapter ID
b = SCSI channel on host adapter
c = SCSI-ID
d = LUN (Logical Unit Number)
Check the installation with the following command:
>> cat scsi /prog/scsi/scsi [ENTER]
Removing a hot-swap drive
Remove the device from the configuration with the following command:
>> echo scsi remove-single-device a b c d > /prog/scsi/scsi [ENTER]
The parameters have the following meaning:
a = Host adapter ID
b = SCSI channel on host adapter
c = SCSI-ID
d = LUN (Logical Unit Number)
Check the deinstallation with the following command:
>> cat scsi /prog/scsi/scsi [ENTER]
Pull out the DAT drive by the handle.
14 - English A26361-H939-Z100-1-7419