Technical data

DAT 72 (DDS Gen5) 36/72 GBYTE
!
Never remove a drive during tape operation or data transfer.
Make sure that the drive to be replaced is inactive and remove any storage medium from the
drive.
Deactivate the device in the Device Manager (Windows 2000, Server 2003).
Pull out the DAT drive by the handle.
Install the new tape device in the same slide-in module!
i
Use the same slide-in module, as otherwise you must reinstall the device (see the section
"Hot-swap installation in a PRIMERGY server (under Windows) ").
Insert the storage medium in the new drive.
Wait at least 30 seconds.
Start the backup software and check whether the drive you have just mounted still has the
same device configuration.
The tape is now ready for operation.
A26361-H939-Z100-1-7419 English - 13