Technical data
DAT 72 (DDS Gen5) 36/72 GBYTE
Windows Server 2003, Windows 2000 or LINUX SLES 8.x:
► Install the operating system.
► Check the firmware and drivers for the SCSI/RAID controller.
► Install the DAT drive.
► Select Scan for Hardware Changes in the Device Manager (Windows 2000,
Windows Server 2003) to detect the DAT drive.
With LINUX, proceed as described in the section "Installing or replacing a drive in a LINUX
server".
► Install the necessary tape drivers.
► Install the backup software after the drive has been detected.
Using NT-Backup
► Restart your server.
► Start NT-Backup.
The tape is now ready for operation.
Using CA ARCserve 2000/BrightStore 9
► Run ARCserve.
The new DAT drive is automatically detected when ARCserve/Bright Store is started.
► Check whether the DAT drive appears under ARCserve/Bright Store Device.
The tape is now ready for operation.
Hot-swap installation in a PRIMERGY server (under Windows)
Proceed as follows to install a new drive under Windows 2000 or Windows Server 2003.
Backup software is already installed
i
The following procedure requires you to have administrator rights.
► Make sure that no backup activity is running.
► Close all open applications.
► Check the firmware and drivers of the SCSI/RAID controller.
► Install the DAT drive.
► Wait at least 30 seconds.
► Select Scan for Hardware Changes in the Device Manager (Windows 2000,
Windows Server 2003) to detect the DAT drive.
► Install the required driver.
A26361-H939-Z100-1-7419 English - 11