Technical data

DAT 72 (DDS Gen5) 36/72 GBYTE
2
1
► Plug the 68-pin plug into the SCSI interface (1). The DAT drive automatically adjusts to LVD or
SE.
► Plug the 4-pin power supply plug into the power supply socket of the DAT drive (2).
Installing 3 1/4 inch version (hot-swap)
The 3 1/2 inch version of the DAT drive is intended for PRIMERGY servers and PRIMERGY
subsystems in which a magnetic tape drive is to installed during operation (hot-swap).
By installing the DAT drive, two installation bays are occupied that are then no longer available for
HDD modules.
The module is connected to the SCSI backplane without cables via the SCA interface (Single
Connector Attachment).
!
Please note the information provided in the chapter "Important notes" in the Operating
Manual of the PRIMERGY server or in the manual "Safety and Ergonomics".
A26361-H939-Z100-1-7419 English - 9