Specifications

BULB INSTALLATION
CAUTION: Always handle halogen bulbs with a soft cloth.
Do not touch the bulb with your bare hand as
it will shorten the life of the bulb.
(1) Do not touch the floodlight while it is in use or still
hot. Allow it to cool (about 5 minutes) before
touching it.
(2) Do not use halogen bulb rated higher than 500
watts.
(3) Disconnect the power cord or wall switch. Unscrew
retaining screw on the front of the floodlight. This will
release front surround (FIGURE 3).
FIGURE 3
(4) Raise front surround. Lift off retaining lugs (FIGURE
4).
FIGURE 4
(5) Unwrap halogen bulb, taking care that the fingers do
not touch the bulb. Push one end into either of the
spring loaded sockets. Locate the other end into the
other socket (FIGURE 5).
FIGURE 5
(6) Carefully replace front surround making sure that
the seal is correctly positioned. Screw up tightly
(FIGURE 6).
2
FIGURE 6
INSTALLATION
To facilitate installation, it is essential to get a drill and a
screwdriver ready. Select a location for the unit based on
the coverage angles shown in FIGURE 7.
UNIT(M)
COVERAGE ANGLES
FIGURE 7
Install a wall switch adjacent to the power source
(FIGURE 8). This will help you operate this motion
sensor floodlight with ease. See OPERATION for further
information.
FIGURE 8
WIRING INSTRUCTION
(1) Switch off the power source or wall switch.
(2) Remove the mounting bracket from the floodlight.
Drill the wall and screw the bracket onto the wall
using suitable plastic wall plugs and screws (not
included). Check that the bracket is securely fitted
on the wall (FIGURE 9).
3