Specifications

754HF1/180/300 300W Security Floodlight Installation Instructions

8 of 20

3.0 Commissioning Procedure

3.1 Walk Testing Procedure

1. The sensor will rotate from left to right. Adjust the sensor to point in the

desired direction (see Diagram A and H for the different sensor patterns and

lens masking).

2. Set the two adjustment knobs on the sides of the sensor (Diagram C) to the

following positions:

3. The unit will now operate during daytime as well as at night, illuminating the lamp

for approximately ﬁve seconds each time. This allows testing to be carried out to

establish the best position for the sensor.

4. Switch on the mains power. The lamp will immediately illuminate as the unit goes

through its ‘warm-up’ period. After approximately one to two minutes the lamp will

extinguish. Try to remain outside the detection area during the warm-up period.

5. Walk across the detection area approximately ﬁve metres from the unit. As you

cross a detection ‘zone’ the lamp will illuminate. Now stand still until the lamp

extinguishes (this should take approximately ﬁve seconds).

6. Start moving again. As you cross each ‘zone’ the lamp will illuminate. Repeat the

above, walking at various distances and angles to the unit. This will help you to

establish the detection pattern.

7. The units sensor module can be adjusted horizontally from left to right. If the

detection area is too small for your requirements, try turning the sensor head.

This can increase the coverage distance or will reduce the range should a smaller

coverage area be required (see Diagram G to see how to adjust the ﬂoodlight

beam to suit).

PIR TIMER

5 Seconds Fully anti-clockwise

SUNSET TIMER

1 Hour Fully anti-clockwise

LUX

Full Sunlight Fully clockwise

DIM

0% (Off) Fully anti-clockwise