Specifications

754HF1/180/300 300W Security Floodlight Installation Instructions
6 of 20
© Clipsal Australia Pty Ltd
2.2 Mounting the Unit
1. Remove the wall plate from the unit by inserting a terminal screwdriver into the
slot at the top (see Diagram D).
2. Mark the position of the fitting holes. Drill the holes. Insert wallplugs into the holes.
3. BEFORE SECURING THE WALLPLATE TO THE WALL PIERCE AND PASS THE
CABLE THROUGH THE GROMMET.
4. Attach the wall plate to the wall (see Diagram E).
2.3 Electrical Connections
1. Connect the cable to the terminal block on the wall plate as follows (see
Connection Diagram F):
2. Ensure that the connections are secure.
3. To reattach the unit to the wall plate line up the two pins at the top of the unit.
4. Push the unit against the wall plate and the unit will ‘click’ into place. Ensure that
the bottom clip is fully closed to ensure a weatherproof seal (see Diagram E).
NEUTRAL (Blue/Black) N
EARTH (Green/Yellow)
ACTIVE/LIVE (Brown/Red) L
NOTE:
It is recommended that a separate switch be installed inside the premises to switch
power to the unit ON and OFF. This allows the sensor to be easily switched off
when not required or for maintenance purposes (refer to ‘Manual Override Mode’
on page 11).