Specifications

754HF1/180/300 300W Security Floodlight Installation Instructions
11 of 20
© Clipsal Australia Pty Ltd
3.5 Special Functions
MANUAL OVERRIDE MODE
The light can be switched on for longer time periods by use of the MANUAL
OVERRIDE MODE. The light can be activated AT NIGHT by using the internal wall
switch / circuit breaker.
Switch the internal wall switch / circuit breaker OFF/ON within 2 seconds. The
unit will now illuminate continuously (OVERRIDE ON), and will remain ON until
MANUAL OVERRIDE MODE is cancelled, or until dawn the following day
(whichever comes first).
To cancel MANUAL OVERRIDE MODE and switch the unit back into AUTOMATIC
MODE, flick the internal wall switch / circuit breaker OFF/ON within 1 second. The
lamp will extinguish and the unit will return to normal automatic operation.
SUNSET SWITCH / COURTESY LIGHT MODE
This unit incorporates a SUNSET SWITCH MODE, designed to automatically activate
the COURTESY LIGHT at dusk. The unit will remain on at a convenient DIM setting
(1 - 95%) for a period of time set by the user (1 - 8 hours) each night.
To enable SUNSET SWITCH MODE, simply:
• Set the SUNSET TIMER adjustment knob as required (1 - 8 hours).
• Set the DIM CONTROL adjustment knob to any other setting other than 0% (fully
anti-clockwise).
At Sunset each evening, the COURTESY LIGHT will illuminate to a user defined low
level dimmer setting between 1 and 95% of maximum brightness, for the set time
between 1 and 8 hours.
Should movement be detected by the sensor when the COURTESY LIGHT is active,
the light will go to full brightness for the period set by the PIR TIMER, after which it
will drop back down to the low level DIM setting.
After the SUNSET TIMER period has elapsed, the lamp will extinguish and the unit
will resume normal operation, responding to movement as required.
Note that SUNSET SWITCH MODE will NOT reset to AUTOMATIC MODE at dawn, it
will repeat each night until reset by the user. To disable the SUNSET SWITCH MODE
simply set the DIM CONTROL to 0% (fully anti-clockwise).