User Manual

Quanta Microsystems, Inc.
Subject:
ZM10 operation manual-RF mode
Rev: 0.2
Doc No.
OP_ZM10X-1
Revised Date:
2008/03/28 Page: 4 of 10
QMI PROPERTY & CONFIDENTIAL!
4
 Adaptor board placement and jumper selection
 J_CURRENT: For DC current measurement use; Default is short by Jumper.
 J_DC: DC input selection
― 1-2 Short by Jumper : Use USB +5VÆLDOÆ3.3V
― 2-3 Short by Jumper : Use RCA Jack
― Open : Use J_3V pin header
 CN USB: Insert USB A-type cable connect to USB host to provide +5Vdc.
 CN_RCA : Provide +4~7Vdc by RCA Jack.
 J_3V : Provide +2.7~3.3V by pin header, positive port are marked in square.
 CN9 : D-SUB9 for UART console.
 CON4 : insert 4-wire cable connect to DUT for FW download.
 CON6 : insert 6-wire cable connect to DUT for RF testing.