User's Manual
Table Of Contents
- Quanta_WCM_UserGuide_Ver 1 01_20070802.pdf
- 1. Introduction
- 2. Hardware installation
- 3. Driver installation and un-installation
- 3.1. Un-install the previous WiMAX NDIS Driver
- 3.2. Install WiMAX NDIS Driver
- 4. WiMAX Utility installation
- 4.1. .NET Framwork 2.0
- 4.2. WinPcap Library installation
- 4.3. Quanta WiMAX Connection Manager installation
- 5. Configure the WiMAX Card by Quanta WiMAX Connection Manager
- 5.1. Use Quanta WiMAX Connection Manager to setup WiMAX connection without security configuration
- 5.2. Use Quanta WiMAX Connection Manager to setup WiMAX connection with security configuration
- 6. Appendix
- 6.1. Use Quanta Config File Editor to setup configuration file parameters
- 6.2. Configuration File Parameters
- 6.3. Setup WCM network configuration to static IP address
- WC510_FCC_CE_Statement.pdf
Quanta Computer Inc.
http://www.quantatw.com/
4. WiMAX Utility installation
4.1. .NET Framwork 2.0
In order to run Quanta WiMAX Connection Manager (WCM), the .NET Framework Version 2.0 (or higher)
must be installed. The .NET Framework 2.0 is already installed on many Windows XP computers. If you see a
Windows error message that begins ‘This application has failed to start because the application configuration is
incorrect. …’ as soon as you try running the WCM, it’s very likely that you do not have the .NET 2.0
framework installed on your computer.
To obtain the Framework, go to the Microsoft Download Center (
http://www.microsoft.com/downloads/),
search for “.NET Framework Version 2.0 Redistributable Package (x86)”, and follow the installation
instructions given by Microsoft.
4.2. WinPcap Library installation
In order to run the Quanta WCM with EAP authentication, the WinPcap package must be installed on your
computer. WinPcap is already installed on many Windows XP computers. If you see a Windows error message
stating that the “wpcap.dll” file could not be found, you will need to install WinPCAP.
To obtain WinPCAP, go to
http://www.winpcap.org/, click on “Get WinPcap” on the left frame, download
the “WinPcap auto-installer (driver + DLLs)”, and run this installer. You do not need to install the
WinDump package.
1. Download “ WinPcap_4_0.exe” from
http://www.winpcap.org/.
2. Please execute “WinPcap_4_0.exe”, and
click the “
Next >” button.
Page 9