User's Manual
Table Of Contents
- Quanta_WCM_UserGuide_Ver 1 01_20070802.pdf
- 1. Introduction
- 2. Hardware installation
- 3. Driver installation and un-installation
- 3.1. Un-install the previous WiMAX NDIS Driver
- 3.2. Install WiMAX NDIS Driver
- 4. WiMAX Utility installation
- 4.1. .NET Framwork 2.0
- 4.2. WinPcap Library installation
- 4.3. Quanta WiMAX Connection Manager installation
- 5. Configure the WiMAX Card by Quanta WiMAX Connection Manager
- 5.1. Use Quanta WiMAX Connection Manager to setup WiMAX connection without security configuration
- 5.2. Use Quanta WiMAX Connection Manager to setup WiMAX connection with security configuration
- 6. Appendix
- 6.1. Use Quanta Config File Editor to setup configuration file parameters
- 6.2. Configuration File Parameters
- 6.3. Setup WCM network configuration to static IP address
- WC510_FCC_CE_Statement.pdf
Quanta Computer Inc.
http://www.quantatw.com/
3.2. Install WiMAX NDIS Driver
1. Please, un-install your previous WiMAX
NDIS driver before you install the new
WiMAX NDIS driver (reference: Chapter
3.1 ).
2. Please, use WinRAR to decompress the
WiMAX_Driver.rar to your C disk.
3. It will create a WiMAX_Driver folder in
your C disk (C:\ WiMAX_Driver).
4. When first connect the CardBus Subscriber
to your laptop, the operating system
(Windows XP) will detect a new device and
start the “Found New Hardware Wizard”
automatically.
5. Please select the “No, not this time” option
6. Click the “
Next >” button to continue the
installation.
7. Please select the “Install from a list or
specific location (Advanced)” option.
8. Click the “
Next >” button to continue the
installation.
Page 6