User's Manual
Table Of Contents
- Quanta_WCM_UserGuide_Ver 1 01_20070802.pdf
- 1. Introduction
- 2. Hardware installation
- 3. Driver installation and un-installation
- 3.1. Un-install the previous WiMAX NDIS Driver
- 3.2. Install WiMAX NDIS Driver
- 4. WiMAX Utility installation
- 4.1. .NET Framwork 2.0
- 4.2. WinPcap Library installation
- 4.3. Quanta WiMAX Connection Manager installation
- 5. Configure the WiMAX Card by Quanta WiMAX Connection Manager
- 5.1. Use Quanta WiMAX Connection Manager to setup WiMAX connection without security configuration
- 5.2. Use Quanta WiMAX Connection Manager to setup WiMAX connection with security configuration
- 6. Appendix
- 6.1. Use Quanta Config File Editor to setup configuration file parameters
- 6.2. Configuration File Parameters
- 6.3. Setup WCM network configuration to static IP address
- WC510_FCC_CE_Statement.pdf
Quanta Computer Inc.
http://www.quantatw.com/
3. Driver installation and un-installation
3.1. Un-install the previous WiMAX NDIS Driver
1. You have to plug the WiMAX Connection
Manager card into your laptop before
unload the old WiMAX NDIS driver.
2. Right-click on “My Computer”, in the
Start menu, and choose “Properties”
3. On the “Hardware” tab, choose “Device
Manager”
4. Expand the “Network Adapters”entry
5. Right-click on “BCM CARDBUS t3
Network device”and select “Uninstall”.
6. Choose “OK” to confirm the device
removal.
7. The old WiMAX NDIS driver has been
removed.
Page 5