User's Manual
Table Of Contents
- Quanta_WCM_UserGuide_Ver 1 01_20070802.pdf
- 1. Introduction
- 2. Hardware installation
- 3. Driver installation and un-installation
- 3.1. Un-install the previous WiMAX NDIS Driver
- 3.2. Install WiMAX NDIS Driver
- 4. WiMAX Utility installation
- 4.1. .NET Framwork 2.0
- 4.2. WinPcap Library installation
- 4.3. Quanta WiMAX Connection Manager installation
- 5. Configure the WiMAX Card by Quanta WiMAX Connection Manager
- 5.1. Use Quanta WiMAX Connection Manager to setup WiMAX connection without security configuration
- 5.2. Use Quanta WiMAX Connection Manager to setup WiMAX connection with security configuration
- 6. Appendix
- 6.1. Use Quanta Config File Editor to setup configuration file parameters
- 6.2. Configuration File Parameters
- 6.3. Setup WCM network configuration to static IP address
- WC510_FCC_CE_Statement.pdf
Quanta Computer Inc.
http://www.quantatw.com/
Corr2PhyFlags This parameter is currently not used. It is a
placeholder for a bit map for
enabling/disabling Corrigendum-2 updates in
PHY. This should be 0 unless testing for
Corrigendum-2.
6.3. Setup WCM network configuration to static IP address
1. Plugin WCM card to your Laptop.
2. Setup WCM with a static IP address as the
below procedures.
3. Open Windows Start menu.
4. Open Control Panel.
5. Classic view: Open Network Connections
Category view: Select Network and
Internet Connections, and then Network
Connections.
6. Double-click on your active LAN or
Internet connection.
7. Click Properties.
8. In the General tab, highlight the Internet
Protocol (TCP/IP) item, and click
Properties.
This opens the Local Area Connections Properties window
9. In the General tab, click “Use the following
IP address” and input as below:
- IP address: The static IP address you want to assign to
computer (192.168.0.200)
- Subnet mask: 255.255.255.0
- Default gateway: skip.
10. In “Use the following DNS server
addresses”, skip.
11. Click OK.
12. Click OK to close each window.
Page 35