User's Manual

Quanta Computer Inc.
http://www.quantatw.com/
Page 33
ArqType
ARQ Reserved #1
ARQ Reserved #2
ARQ Reserved #3
ARQ Reserved #4
MacParameter 0: Broadcast CID value 0xffff
1: Broadcast CID value 0xfeff
UL PRBS 0: UL PRBS seed encoded to 0.
1: UL PRBS based on frame number
Random FA Select
Harq Enable 0: Disable HARQ
1: Enable HARQ
Compressed Map Enable 0: Disable Compressed Map
1: Enable Compressed Map
Default DIUC This value is set as the preferred DIUC setting
in the unicast ranging request to the BS
EEPROM Start 0x20001000: For MII interface
0x10000200: For all other interface
Customize Each byte of this parameter has a special
meaning. It is organized as
<Byte3>< Byte2><Byte1><Byte0>
Byte3: 00 Full MAC mode selected
03 VSG mode selected
Byte2: Interface type
Byte1: Controls MAC/PHY layer functions
Byte0: Reserved
Example:
Customize = 0x03000100
Firmware Options Bit 0 : Skip link down request bit:
Bit 0 set to 0: enable link down notification
and authentication during resync
Bit 0 set to 1: The firmware doesn’t honor the
LINK DOWN request from the driver.
Similarly, the firmware does not wait for the
LINK UP request to start re-entry.
Please note that firmware waits for the
LINKUP request from the driver to start the
network entry after boot up even if this bit is
set
Bit 1: Control MAC management message
logging.
Bit 1 set to 0: Enable MAC management
message logging.
Bit 1 set to 1: Disable MAC management
message logging.
Bandwidth 5000000: 5 MHz
7000000: 7 MHz
8750000: 8.75 MHz
10000000: 10 MHz
Example:
Bandwidth = 10000000
ShutDown Timer Value Shutdown value in terms of frames
EncrSupport 0: Disable Encryption
1: Enable Encryption