User's Manual
Table Of Contents
- Quanta_WCM_UserGuide_Ver 1 01_20070802.pdf
- 1. Introduction
- 2. Hardware installation
- 3. Driver installation and un-installation
- 3.1. Un-install the previous WiMAX NDIS Driver
- 3.2. Install WiMAX NDIS Driver
- 4. WiMAX Utility installation
- 4.1. .NET Framwork 2.0
- 4.2. WinPcap Library installation
- 4.3. Quanta WiMAX Connection Manager installation
- 5. Configure the WiMAX Card by Quanta WiMAX Connection Manager
- 5.1. Use Quanta WiMAX Connection Manager to setup WiMAX connection without security configuration
- 5.2. Use Quanta WiMAX Connection Manager to setup WiMAX connection with security configuration
- 6. Appendix
- 6.1. Use Quanta Config File Editor to setup configuration file parameters
- 6.2. Configuration File Parameters
- 6.3. Setup WCM network configuration to static IP address
- WC510_FCC_CE_Statement.pdf
Quanta Computer Inc.
http://www.quantatw.com/
3. Please, open the
“C:\WINDOWS\system32\drivers\
macxvi.cfg” configuration file and click
“Open” button.
4. You can modify the configuration
parameters after you load macxvi.cfg
finished.
5. Please, refer to next chapter that descript
configuration parameters what you can
modify.
6. Please, click the “File” and select “Save” or
“Save as” to save your modified.
6.2. Configuration File Parameters
The following table shows configuration parameters as found in Config File Version 17. You can use
“Quanta Config File Editor” utility to edit the “C:\WINDOWS\system32\drivers\ macxvi.cfg”
configuration file.
Parameter Description Comment
Configuration File Version This parameter is changed whenever a
parameter is added or dropped. In other words
this defines the config file template version.
A configuration file is
matched to a specific
firmware release.
Center Frequency 0: Enable scanning
Non Zero: specific center frequency in MHz.
Example: Center Frequency
= 2545.75 (should be a
multiple of 0.25 MHz)
Page 31