User's Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparing the workstation for use
- Working with the workstation
- Switching the workstation on
- Switching off the workstation
- Indicators
- Keyboard
- Display settings
- Battery
- Using the power-management features
- Hard disk
- Inserting and removing modules
- Optical drives
- Floppy Disk Drive
- 56k-Modem
- Connecting IEEE1394 (FireWire)
- PC cards
- SmartCards
- Microphone and loudspeakers
- Fingerprint reader
- Property and data protection
- Connecting external devices
- Settings in BIOS Setup
- Troubleshooting and tips
- Installing new software
- Saving and restoring system files
- Restoring the hard disk contents under Windows
- The workstation's date or time is incorrect
- Battery indicator does not illuminate
- The LCD screen of the workstation remains blank
- The workstation's LCD display is difficult to read
- The external monitor stays blank
- The external monitor is blank or the image is unstable
- The workstation does not start after switch on
- The workstation stops working
- The mouse does not work
- The floppy disk cannot be written
- The printer does not print
- Acoustic warnings
- Error messages on the screen
- Memory expansion
- Technical data
- Index
Troubleshooting and tips
70 A26391-K115-Z120-2-7619
Not enough Save-to-Disk partition or file exists on Fixed Disk - Save-to-Disk feature is
disabled.
The Save-to-Disk mode is not available to you, as no memory space has been assigned to this
mode.
Ê Use the PHDISK service programme to assign the memory space required for this mode.
Press <F1> to resume, <F2> to SETUP.
This error message appears if an error occurs during the self-test before starting the operating
system.
Ê Press the [F1] function key to start the operating system.
Ê Enter the BIOS Setup programme by pressing
[F2].
Previous boot incomplete - Default configuration used
Due to an error during the previous system boot, default values were used for certain settings.
Check the BIOS Setup and the settings.
Ê Press the
[F1] function key when prompted to do so.
Real Time clock error
Ê Contact your sales outlet or our Hotline/Help Desk.
nnnnK Shadow RAM failed at offset: xxxx Failing Bits: zzzz
Ê Contact your sales outlet or our Hotline/Help Desk.
System battery is dead - Replace and run SETUP
Ê Contact your sales outlet or our Hotline/Help Desk.
System cache error - Cache disabled
Ê Contact your sales outlet or our Hotline/Help Desk.
nnnnK System RAM failed at offset: xxxx Failing Bits: zzzz
Ê If you have installed a DIMM, you should remove the module and reboot the workstation.
If the error message is no longer displayed, the error concerned is DIMM-related. Should you
receive this error message again, please contact your dealer.
System timer error
Ê Contact your sales outlet or our Hotline/Help Desk.