User's Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparing the workstation for use
- Working with the workstation
- Switching the workstation on
- Switching off the workstation
- Indicators
- Keyboard
- Display settings
- Battery
- Using the power-management features
- Hard disk
- Inserting and removing modules
- Optical drives
- Floppy Disk Drive
- 56k-Modem
- Connecting IEEE1394 (FireWire)
- PC cards
- SmartCards
- Microphone and loudspeakers
- Fingerprint reader
- Property and data protection
- Connecting external devices
- Settings in BIOS Setup
- Troubleshooting and tips
- Installing new software
- Saving and restoring system files
- Restoring the hard disk contents under Windows
- The workstation's date or time is incorrect
- Battery indicator does not illuminate
- The LCD screen of the workstation remains blank
- The workstation's LCD display is difficult to read
- The external monitor stays blank
- The external monitor is blank or the image is unstable
- The workstation does not start after switch on
- The workstation stops working
- The mouse does not work
- The floppy disk cannot be written
- The printer does not print
- Acoustic warnings
- Error messages on the screen
- Memory expansion
- Technical data
- Index
Troubleshooting and tips
68 A26391-K115-Z120-2-7619
Acoustic warnings
A beep sounds every few seconds
The battery is almost flat.
Ê Charge the battery.
Error messages on the screen
This section describes the error messages generated by the BIOS-Setup. Error messages displayed
by the operating system or programmes are described in the relevant manuals.
CMOS Battery Bad
If the error message occurs repeatedly, then the buffer battery in the workstation is dead.
Ê Connect the workstation via its power adapter to a mains outlet. The buffer battery will take
approximately two days to complete its recharge.
If the error message appears repeatedly, please contact the place of purchase or our
Hotline/Help Desk.
System CMOS checksum bad – Default configuration used
The system configuration information is incorrect.
Ê Restart the workstation.
Ê Enter the BIOS Setup programme by pressing
[F2].
Ê Select the Exit menu in the BIOS Setup.
Ê Select the Default Setup entry and click on OK.
If the error message appears repeatedly, please contact the place of purchase or our
Hotline/Help Desk.
Insert system diskette and press Enter key to reboot
The operating system cannot be loaded or the hard disk contains no operating system or is not
formatted.
Ê Insert a system disk.
Ê Press any key to continue.
Invalid system disk - Replace the disk, and then press any key
The inserted disk is not a system disk or the inserted system disk is defective.
Ê Insert another system disk.
Ê Press any key to continue.
If you wish to boot from floppy disk:
Ê Insert a system disk.
Ê Press any key to continue.
Diskette drive A error
Ê Start the BIOS Setup and make sure that the parameter for floppy disk drive A has been set to
the format 1.44 Mbyte, 3 1/2 inch.