User's Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparing the workstation for use
- Working with the workstation
- Switching the workstation on
- Switching off the workstation
- Indicators
- Keyboard
- Display settings
- Battery
- Using the power-management features
- Hard disk
- Inserting and removing modules
- Optical drives
- Floppy Disk Drive
- 56k-Modem
- Connecting IEEE1394 (FireWire)
- PC cards
- SmartCards
- Microphone and loudspeakers
- Fingerprint reader
- Property and data protection
- Connecting external devices
- Settings in BIOS Setup
- Troubleshooting and tips
- Installing new software
- Saving and restoring system files
- Restoring the hard disk contents under Windows
- The workstation's date or time is incorrect
- Battery indicator does not illuminate
- The LCD screen of the workstation remains blank
- The workstation's LCD display is difficult to read
- The external monitor stays blank
- The external monitor is blank or the image is unstable
- The workstation does not start after switch on
- The workstation stops working
- The mouse does not work
- The floppy disk cannot be written
- The printer does not print
- Acoustic warnings
- Error messages on the screen
- Memory expansion
- Technical data
- Index
Troubleshooting and tips
66 A26391-K115-Z120-2-7619
The workstation does not start after switch on
If the workstation does not start after switch on, this may be due to one of the following:
The battery is not installed correctly.
Ê Switch off the workstation.
Ê Check whether the battery is installed correctly in its compartment.
Ê Switch the workstation on.
The battery is dead
Ê Charge the battery.
Or
Ê Install a charged battery.
Or
Ê Connect the power adapter to the workstation.
The power adapter is not connected correctly.
Ê Switch off the workstation.
Ê Check whether the power adapter is connected correctly to the workstation.
Ê Check whether the power cable is plugged properly into the power adapter and into the mains
outlet.
Ê Switch the workstation on.
The workstation stops working
If the workstation stops working, this may have the following reasons:
The workstation is in Standby or Suspend mode
Ê Reactivate the workstation by pressing a key (Standby mode) or by switching it back on
(Suspend mode).
An application programme has caused the malfunction
Ê Close the application programme or restart the workstation by switching it On/Off or with a
warm boot.
The battery is dead
Ê Charge the battery.
Or
Ê Install a charged battery.
Or
Ê Connect the power adapter to the workstation.