User's Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparing the workstation for use
- Working with the workstation
- Switching the workstation on
- Switching off the workstation
- Indicators
- Keyboard
- Display settings
- Battery
- Using the power-management features
- Hard disk
- Inserting and removing modules
- Optical drives
- Floppy Disk Drive
- 56k-Modem
- Connecting IEEE1394 (FireWire)
- PC cards
- SmartCards
- Microphone and loudspeakers
- Fingerprint reader
- Property and data protection
- Connecting external devices
- Settings in BIOS Setup
- Troubleshooting and tips
- Installing new software
- Saving and restoring system files
- Restoring the hard disk contents under Windows
- The workstation's date or time is incorrect
- Battery indicator does not illuminate
- The LCD screen of the workstation remains blank
- The workstation's LCD display is difficult to read
- The external monitor stays blank
- The external monitor is blank or the image is unstable
- The workstation does not start after switch on
- The workstation stops working
- The mouse does not work
- The floppy disk cannot be written
- The printer does not print
- Acoustic warnings
- Error messages on the screen
- Memory expansion
- Technical data
- Index
Connecting external devices Connecting an external keyboard
58 A26391-K115-Z120-2-7619
Connecting an external keyboard
You do not need to switch off your workstation.
Ê Simply connect the external keyboard to the PS/2 port on your workstation.
Connecting an external PS/2 mouse
You do not need to switch off the workstation.
Ê Simply connect the mouse to the PS/2 port on your workstation.
Connecting a serial mouse
Ê Switch off the workstation.
Ê Connect the mouse to the parallel port on your workstation.
Ê Switch the workstation on.
Ê Run the mouse service programme under Start - Settings - Control Panel and select the General
tab.
Ê Select the correct mouse type.
Ê Restart the workstation.
Using the parallel port
Ê Switch off the workstation.
Ê Connect the data cable of the printer to the parallel port on the workstation.
Ê Plug the printer power cable into the mains outlet.
Ê First switch on the printer, then the workstation.
Using the serial port
Ê Switch off the workstation.
Ê Connect the data cable of the printer to the parallel port on the workstation.
Ê Plug the printer power cable into the mains outlet.
Ê First switch on the printer, then the workstation.