User's Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparing the workstation for use
- Working with the workstation
- Switching the workstation on
- Switching off the workstation
- Indicators
- Keyboard
- Display settings
- Battery
- Using the power-management features
- Hard disk
- Inserting and removing modules
- Optical drives
- Floppy Disk Drive
- 56k-Modem
- Connecting IEEE1394 (FireWire)
- PC cards
- SmartCards
- Microphone and loudspeakers
- Fingerprint reader
- Property and data protection
- Connecting external devices
- Settings in BIOS Setup
- Troubleshooting and tips
- Installing new software
- Saving and restoring system files
- Restoring the hard disk contents under Windows
- The workstation's date or time is incorrect
- Battery indicator does not illuminate
- The LCD screen of the workstation remains blank
- The workstation's LCD display is difficult to read
- The external monitor stays blank
- The external monitor is blank or the image is unstable
- The workstation does not start after switch on
- The workstation stops working
- The mouse does not work
- The floppy disk cannot be written
- The printer does not print
- Acoustic warnings
- Error messages on the screen
- Memory expansion
- Technical data
- Index
Working with the workstation Using the power-management features
34 A26391-K115-Z120-2-7619
Using the power-management features
The workstation uses less power when the power management features are enabled. You will then
be able to work longer when using the battery before having to recharge it.
i
If you are connected to a network or use the integrated modem, PC LAN card, or PC
modem card, we advise against enabling an energy saving mode. This could lead to an
interruption of your network connection.
When not using the workstation for long periods of time, first end the energy saving mode,
then switch off the workstation. Never switch off the workstation with the
Suspend/Resume button while the workstation is in one of the energy-saving modes.
If your workstation is in an energy-saving mode mode:
· Do not connect any external peripheral devices.
· Do not disconnect any external peripheral devices.
· Do not attempt to switch the workstation on if the built-in battery is flat.
· Do not change or remove the floppy disk, if inserted.
· Do not add or remove RAM.
· Do not add or remove a PC card.
· Do not replace or remove the battery.