User's Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparing the workstation for use
- Working with the workstation
- Switching the workstation on
- Switching off the workstation
- Indicators
- Keyboard
- Display settings
- Battery
- Using the power-management features
- Hard disk
- Inserting and removing modules
- Optical drives
- Floppy Disk Drive
- 56k-Modem
- Connecting IEEE1394 (FireWire)
- PC cards
- SmartCards
- Microphone and loudspeakers
- Fingerprint reader
- Property and data protection
- Connecting external devices
- Settings in BIOS Setup
- Troubleshooting and tips
- Installing new software
- Saving and restoring system files
- Restoring the hard disk contents under Windows
- The workstation's date or time is incorrect
- Battery indicator does not illuminate
- The LCD screen of the workstation remains blank
- The workstation's LCD display is difficult to read
- The external monitor stays blank
- The external monitor is blank or the image is unstable
- The workstation does not start after switch on
- The workstation stops working
- The mouse does not work
- The floppy disk cannot be written
- The printer does not print
- Acoustic warnings
- Error messages on the screen
- Memory expansion
- Technical data
- Index
Display settings Working with the workstation
A26391-K115-Z120-2-7619 29
Display settings
Setting the desktop area
You can change the screen resolution under Start - Settings- Control Panel - Display - Settings and then
selecting from the Resolution field.
Adjusting the font size
Under Start - Settings - Control Panel - Display - Settings you can choose between a larger and a
smaller font in the Font size field.
Adjusting the speed of the mouse pointer
You can change the speed of the mouse pointer under Start - Settings - Control Panel - Mouse and
clicking on the Motion tab.
Setting the display brightness
You can adjust the brightness of your LCD screen with the keys
[Fn] and [F12] or [Fn] and [F11]:
With [Fn] and [F12], screen brightness will be reduced and with [Fn] and [F11] increased.
Synchronising the display on the LCD screen and an external monitor
Your workstation supports the simultaneous display on the LCD monitor and an external monitor. If
the picture does not appear correctly on the LCD monitor, press the key combination
[Fn] + [F10]
several times, or switch the external monitor off and then on again. This achieves good picture
synchronisation.