User's Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparing the workstation for use
- Working with the workstation
- Switching the workstation on
- Switching off the workstation
- Indicators
- Keyboard
- Display settings
- Battery
- Using the power-management features
- Hard disk
- Inserting and removing modules
- Optical drives
- Floppy Disk Drive
- 56k-Modem
- Connecting IEEE1394 (FireWire)
- PC cards
- SmartCards
- Microphone and loudspeakers
- Fingerprint reader
- Property and data protection
- Connecting external devices
- Settings in BIOS Setup
- Troubleshooting and tips
- Installing new software
- Saving and restoring system files
- Restoring the hard disk contents under Windows
- The workstation's date or time is incorrect
- Battery indicator does not illuminate
- The LCD screen of the workstation remains blank
- The workstation's LCD display is difficult to read
- The external monitor stays blank
- The external monitor is blank or the image is unstable
- The workstation does not start after switch on
- The workstation stops working
- The mouse does not work
- The floppy disk cannot be written
- The printer does not print
- Acoustic warnings
- Error messages on the screen
- Memory expansion
- Technical data
- Index
Important notes Transporting the workstation
8 A26391-K115-Z120-2-7619
Disposal and recycling
This device has been manufactured to the highest possible degree from materials which can be
recycled or disposed of in a manner that is not environmentally damaging. The device may be taken
back after use to be recycled, provided that it is returned in a condition that is the result of normal
use. Any components not reclaimed will be disposed of in an environmentally acceptable manner.
Do not throw lithium batteries into the household waste. They must be disposed of in accordance
with local regulations concerning special waste.
If you have any questions on disposal, please contact your local office, our Hotline/Help Desk, or:
Fujitsu Siemens Computers GmbH
Recyclingcenter
D-33106 Paderborn
Tel: +49 5251 81 80 10
Fax: +49 5251 81 80 15
CE marking
The shipped version of this device complies with the requirements of the EEC directives
89/336/EEC "Electromagnetic compatibility" and 73/23/EEC "Low voltage directive".
GS symbol
In normal screen mode (dark characters against a light background) the LCD panel satisfies the
ergonomic requirements for the GS symbol.
Battery storage
i
If you do not use the batteries for long periods, remove them from the workstation. Never
store the batteries in the unit.
Store the battery in a fully charged state. The battery should be stored in a dry area at a
temperature between 0°C and +30°C. The lower the temperature at which the batteries are stored,
the lower is the rate of self-discharge.
If storing for a long period of time (longer than two months) batteries should be fully charged before
storage.
To be able to use the optimum battery charging capacity, you should work in the battery mode until
the battery is completely discharged, and then recharge the battery.
Transporting the workstation
Please observe the points listed below when transporting your workstation.