User Manual Part 2

Memory extension
!
The notebook must be switched off when installing/removing the memory modules and may
not be in the Suspend mode.
So that the current data can be saved in the Save to Disk suspend mode, sufficient memory
space must be available on the hard disk (at least the size of the main
memory +16 Mbytes).
Install only memory expansions that satisfy the requirements and rules governing safety,
RFI and electromagnetic compatibility and relating to telecommunications terminal
equipment (see the chapter " 錯誤 ! 找不到參照來源。 ").
Use only memory expansions which have been released for your notebook (64, 128, and
256 Mbyte modules, SD RAM, JEDEC 144 pin SO DIMM, 3.3 V).
Never use force when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory module compartment.
The main memory of your notebook can be expanded to a maximum of 512 Mbyte with another
memory module. The notebook will not start without memory modules, as no fixed main memory is
installed.
Removing and installing memory extension
!
Please note the information provided in the " 錯誤 ! 找不到參照來源。 " section in the
chapter " 錯誤 ! 找不到參照來源。 ".
Ê
Switch off the notebook and all devices connected.
Ê
Close the LCD screen so that it locks into place.
Ê
Unplug the power adapter from the mains outlet.
Ê
Remove the battery (see " 錯誤 ! 找不到參照來源。 ").
Ê
Disconnect all cables connected to the notebook.
Ê
Place the notebook upside down on a flat surface.
Removing cover
1
2
3
Ê
Remove the screw (1).
Ê
Lift the cover off the notebook in the direction
of the arrow (2).
Ê
Pull off the cover from the notebook in the
direction of the arrow (3).