User Manual Part 2

錯誤 ! 尚未定義樣式。 錯誤 ! 尚未定義樣式。
To set or change a password, proceed as follows:
Ê
Call BIOS Setup and select the Security menu (see chapter "Settings in BIOS Setup"). You must
additionally change into the Hard Disk Security submenu for the hard disk passwords.
Ê
Mark the Set Supervisor Password or Set User Password field and press the Enter key.
You are asked to enter a password:
Enter new Password:
Ê
Enter the password and press the Enter key.
You are asked to confirm the password:
Re-enter new Password:
Ê
Enter the password again and press the Enter key.
The new password is saved.
Notice: Changes have been saved [continue]
Ê
To prevent booting of the operating system, mark the Password on boot field and select the value
Enabled.
If you do not want to make any other settings, you can exit BIOS Setup.
Ê
Select the option Exit Saving Changes in the Exit menu.
The notebook is rebooted and the new password is effective.
Cancelling passwords
Supervisor / User password
i
If you cancel the supervisor password, you automatically deactivate the user password.
To cancel a password (without setting a new password):
Ê
Call BIOS Setup and select the Security menu (see chapter "Settings in BIOS Setup").
Ê
Mark the Set Supervisor Password or Set User Password field and press the Enter key.
You are asked to enter a password:
Enter new Password:
Ê
Press the Enter key twice.
Ê
Select the option Exit Saving Changes in the Exit menu.
The notebook is rebooted and the password is cancelled.
Hard disk password
To cancel a password (without setting a new password):
Ê
Call BIOS Setup and select the Security menu (see chapter "Settings in BIOS Setup").
Ê
Change into the submenu Hard Disk Security.
Ê
Set the entry HDD password to Disabled in the Hard Disk Security submenu.
You are asked to enter a password:
Enter new Password:
Ê
Press the Enter key twice.