User Manual Part 1

錯誤

尚未定義樣式。

A26391-Kyyy-Z120-1-7619 31

Operating systems with APM (Windows 95, Windows NT with APM

extensions)

For operating systems with APM (Advanced Power Management) you can set the energy-

saving functions in the BIOS Setup (e.g. Suspend to RAM, Save to Disk, LCD off etc.).

Setting energy-saving modes

Call the BIOS Setup.

Set which energy-saving mode you want to use in the Power menu.

Set the Auto Suspend Timeout parameter in the Power menu to a time period after which the

notebook is to be switched into the energy-saving mode.

Suspend to DRAM

In this mode the current data in the main memory (DRAM) is stored. The data is stored for as long as

the notebook is supplied with energy. If the battery is full, the data is stored for a matter of days.

Without a battery and without a power supply the current data is lost.

Save to Disk

So that the current data can be saved, sufficient memory must be available on the hard disk. If the

operating system Windows NT or OS/2 Warp is used, a Save-to-Disk partition must be created on the

hard disk (see manual for respective operating system).

In this case also see the section "PHDISK (for Windows 98 and Windows NT only)".

PHDISK (for Windows 98 and Windows NT only)

The PHDISK service programme reserves the memory space required for the use of Save-to-Disk

mode. The programme creates a file or partition for saving the main memory contents and the system

free sectors are saved in the CMOS after running this programme.

•

Run PHDISK after you have installed or removed memory modules.

• Run PHDISK after you have installed or restored Windows 98.

•

Run PHDISK after you have replaced your hard disk.

•

Run PHDISK if you have received a BIOS error message in conjunction with Save-to-Disk mode

during the self test (POST).

In Windows NT the PHDISK service programme is not supported by the NTFS file system.

In Windows 2000/ME the required memory space on the hard disk is not reserved until you

make the required Hibernate mode settings under Settings - Control Panel - Power

Management.

Running PHDISK

Click on Start and then Shut down in Windows.

Activate the Start computer in MS-DOS mode checkbox and click on Yes.