User's Manual
Table Of Contents
- Contents
- Getting Help
- Checking Out Your Gateway Convertible Tablet PC
- Getting Started
- Installing the battery
- Connecting the ACadapter
- Connecting the dial-up modem
- Connecting to a cable or DSL modem or to an Ethernet network
- Starting your convertible tablet PC
- Turning off your convertible tablet PC
- Restarting (rebooting) your convertible tablet PC
- Status indicators
- Using the keyboard
- Tablet Control Buttons
- Using the EZPad touchpad
- Using the display
- Using the pen
- Adjusting the volume
- Turning your wireless radio on or off
- Using Windows XP TabletPC2005
- Using Drives and Ports
- Managing Power
- Upgrading Your Convertible Tablet PC
- Using the Optional Port Replicator
- Maintaining Your Convertible Tablet PC
- Troubleshooting
- Safety, Regulatory, and Legal Information
- Index
90
www.gateway.com
Chapter 7: Upgrading Your Convertible Tablet PC
10 Pull the memory module out of the slot.
11 Hold the new or replacement module at a 30-degree angle and press
it into the empty memory slot. This module is keyed so it can only
be inserted in one direction. If the module does not fit, make sure
that the notch in the module lines up with the tab in the memory
bay.
12 Gently push the module down until it clicks in place.
13 Replace the memory bay cover and tighten the cover screws.
14 Insert the batteries, then turn your convertible tablet PC over.
15 Reattach the optional port replicator.
16 Connect the power adapter, modem cable, and network cable, then
turn on your convertible tablet PC.
Important Use only memory modules designed for the
Gateway M275.