User's Manual
Table Of Contents
- Contents
- Getting Help
- Checking Out Your Gateway Convertible Tablet PC
- Getting Started
- Installing the battery
- Connecting the ACadapter
- Connecting the dial-up modem
- Connecting to a cable or DSL modem or to an Ethernet network
- Starting your convertible tablet PC
- Turning off your convertible tablet PC
- Restarting (rebooting) your convertible tablet PC
- Status indicators
- Using the keyboard
- Tablet Control Buttons
- Using the EZPad touchpad
- Using the display
- Using the pen
- Adjusting the volume
- Turning your wireless radio on or off
- Using Windows XP TabletPC2005
- Using Drives and Ports
- Managing Power
- Upgrading Your Convertible Tablet PC
- Using the Optional Port Replicator
- Maintaining Your Convertible Tablet PC
- Troubleshooting
- Safety, Regulatory, and Legal Information
- Index
89
www.gateway.com
Adding or replacing memory
6 Turn your convertible tablet PC over so the bottom is facing up.
7 Remove the battery (see “Changing batteries” on page 78).
8 Loosen the two memory bay cover screws, then remove the memory
bay cover.
9 If you are removing a module, gently press outward on the clip at
each end of the memory module until the module tilts upward.
Screws