User's Manual

Battery nearly empty Battery full
Battery half
When the battery is fully discharged, the charging indicator is not displayed and will not appear after the phone has
recharged sufficiently. For safety information regarding the battery, see “Battery Safety” on page 5.
Note: Always turn off the phone before removing the battery.
1.2 SIM Card
Your SIM card identifies your phone on the network and stores your details, including your PIN, call history, and
subscription information. It can also be used to store some phone book data. For more information, see “Contacts” on
page 51.
You should only remove your SIM card when absolutely necessary. If it is lost or damaged, the information stored on it
cannot be retrieved.
1.2.1 Inserting / Removing the SIM Card
Turn to the back of your phone to locate your battery room. To insert or remove the SIM card (Step 1-5):
圖F
Step 1: Remove the battery cover.
圖G
Step 2: Remove the battery.
圖H
Step 3: Push the SIM locker to right to unlock and lift it up.
圖I
Step 4: Insert your SIM card into the SIM card holder with
the card's metallic connector in contact with the phone’s
and the notched corner on the right.
(To remove your SIM, simply lift it off from the SIM card
holder.)
圖J
Step 5: Gently press down the SIM locker and push it to
the left to lock.
1.3 Personal Identification Numbers (PINs)
When you switch on your phone, you may be requested to enter your PIN or phone code if your phone requires you to
do so. This number should be in the documentation supplied by your service provider.
If you enter the wrong PIN for three times in a row your phone will become blocked. You will then require your PUK
number to unblock it. For more information about your PIN and PUK number, see Security on page 24.
1.4 Memory slot
Your phone supports to maximum 512 MB Micro SD Flash memory card. The Memory card slot is located under the
battery. Turn to the back of your phone to locate your battery room.
To insert or remove the Memory card (Step 1-5):
圖K (同圖A)
Step 1: Remove the battery cover.
圖L (同圖G)
Step 2: Remove the battery.