User's Manual

21
Charging the Battery
The charger unit begins to restore the battery power when it is connected to the phone.
Connect the charger plug into the connector at the base side of the phone.
Check that the battery icon is displayed and the LED is lit.
During charging, the charging battery icon is displayed and the LED continues to be lit. When charging is complete, the LED will
goes out. The charging battery icon is displayed and LED is still lit as described even when the phone is turned off during
charging.
If you need to receive calls, the phone can be turned on and with the standby screen displayed while it is charging, although the
total time taken to charge is then increased.
The phone is designed to be charged with the NEC equipment listed with the specifications of your phone.
Changing the Battery
Make sure the phone is turned off. Some settings, stored numbers, and messages may be lost if the battery is removed while
the power is on.
Push the battery catch towards the side of the battery and carefully lift the battery away from the phone.
Put the new battery pack in place with the battery terminal end towards the hinge of the phone. Lower the battery toward
the phone to lock into place.
Battery Latch
Please charge the battery as
much as possible when the
battery is very low.
Using any battery pack or AC
adapter not specified by NEC
for use with this phone may be
dangerous and may invalidate
any warranty and approval
given to the phone. Do not
connect more than one
charger at any time. Do not
leave the charger connected to
the power supply when it is
not in use.
Do not try to charge the
battery if the temperature is
below 5 C (41F) or above 35
C(95F).
Using any battery pack or AC
adapter not specified by the
manufacturer for use with this
phone creates a potential
safety hazard.
NEC.book Page 21 Monday, May 10, 2004 2:46 PM