User's Manual

2 TOSHIBA AT200 User Information Guide
Connecting the AC adaptor
1. Plug the USB connector of the power cable into the USB port on the AC adaptor.
2. Plug the power connector of the power cable into the docking interface on your tablet.
3. Plug the AC adaptor into a live wall outlet.
Turning on/off the power
Press and hold Power button to turn on the tablet. The tablet will vibrate to indicate
the status.
To turn off the tablet, press and hold Power button for approximately 2 seconds and
select OK.
Depending on the model, either a 2-pin or 3-pin AC adaptor will be bundled
with the tablet.
You can charge the tablet by connecting the power cable to a USB port on a
computer. TOSHIBA recommends charging when the tablet goes into sleep
mode.
2-pin
3-pin
Blade.book Page 2 Thursday, September 22, 2011 11:05 AM