User's Manual
the phone should operate as usual.
FCC RF Exposure Information
In August 1996 the Federal Communication (FCC) of the United States
with its action in Report and Order FCC 96-326 adopted an updated
safety standard for human exposure to radio frequency (RF)
electromagnetic energy emitted by FCC regulated transmitters. Those
guidelines are consistent with the safety standard previous set by both
U.S.and international standards bodies.The design of this phone
complies with the FCC guidelines and these international standards.
Use only the supplied or an approved internal antenna. Unauthorized
antennas, modifications, or attachments could impair call quality,
damage the phone, or result in violation of FCC regulations.
FCC Regulations:
This mobile phone complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiated radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible
For compliance could void the user’s authority to operate the equipment.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with
FCC RF exposure requirements, a minimum separation distance of 0.6
inches (1.5 cm) must be maintained between the user's body and the
phone, including the antenna.Third-party belt-clips, holsters, and similar
accessories used by this device should not contain any metallic
components.Body-worn accessories that do not meet these
requirements may not comply with FCC RF exposure requirements and
should be avoided.
For more information about RF exposure, please visit the FCC website
at www.fcc.gov.