User Manual Part 5

240
Chapter 16: Reinstalling Device Drivers
www.gateway.com
Reinstalling Windows NT 4.0 video device
drivers
Use the instructions in this section to reinstall the drivers that support the
video devices in your computer.
To reinstall the Windows NT 4.0 video device driver:
1 Make sure you ran the Windows NT 4.0 Locator utility to find the video
driver. For more information, see “Locating Windows NT 4.0 drivers” on
page 238.
2 Place Disc 1 of the System Restoration Kit into your CD/DVD drive.
3 If the CD starts automatically, close the CD window.
4 If the driver location information for the video driver ends with a file
name (for example, setup.exe), go to Step 5.
- OR -
If the driver location information for your video card driver ends with
a backslash (\), go to Step 10.
5 Click Start, then select Run. The Run dialog box opens.
6 In the Open text box, type the drive letter (usually D:\ where D is the
drive letter of your CD/DVD drive), then type the driver location
(directory path) you found using the procedure in “Locating
Windows NT 4.0 drivers” on page 238.
7 Click OK.
8 Reinstall your video driver by following the on-screen instructions. You
have completed the driver reinstallation.
9 If required, go to “Reinstalling Windows NT 4.0 audio device drivers” on
page 243. Otherwise, go to “Reinstalling the Windows NT Service Pack”
on page 250.
10 Click Start, then select Settings, then Control Panel. The Control Panel
window opens.
Solo9550.book Page 240 Tuesday, June 19, 2001 3:18 PM