User Manual

UANTA COMPUTER INC. CNBU/1KUx
________________________________________________________________________________________
____________________________________________________________________________
1KU Product Specification Rev. 2B Page: 10
- Quanta Confidential -
4.3 Power Consumption
The input voltage is 3.4V ~ 4.2V supplied by the host. But the following table is measured by setting up
through power supply.
4.3.1 LTE Mode (Average)
LTE Cat 3 Current Measurement (B13, 10MHz)
LTE test equipment: Anritsu MT8820C
Active state
Voltage
Data Type
Current at 23dBm (mA)
Current at 10dBm (mA)
Current at 0dBm (mA)
3.4V
MIMO (73.4Mbps)
835
560
435
SISO (36.7Mbps)
800
530
410
4.2V
MIMO (73.4Mbps)
760
480
355
SISO (36.7Mbps)
735
465
330
4.3.2 EVDO Rev. 0 Mode (Average)
Voltage
Current in 23dBm (mA)
Current in 10dBm (mA)
Current in 0dBm (mA)
BC0 CH=387 (800MHz)
3.4V
518
309
292
4.2V
488
298
284
BC1 CH=638 (1900MHz)
3.4V
580
323
300
4.2V
541
315
298
5. AT Command
5.1 3GPP Standard AT Commands
1. AT command set for GSM Mobile Equipment (ME) can be downloaded from
http://www.3gpp.org/ftp/Specs/html-info/0707.htm .
2. AT command set for User Equipment (UE) can be downloaded from
http://www.3gpp.org/ftp/Specs/html-info/27007.htm .
6. FCC
FCC ID: HFS1KU1
This module is complied to FCC requirement, all integrators have to be aware of the following information.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules Rules.
Operation is subject to the following two conditions :
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired