User guide

Table Of Contents

Prepare the physical connection to the network:

Connection Action

Wired

1. Power on the QuantStudio

3D Instrument.

2. Connect one end of a standard category-6 Ethernet cable to

the RJ-45 port on the back panel of the instrument and the

other end to an open network port.

Wireless

1. If required for network setup, record the wireless dongle's

MAC address, which is located on the underside of the device.

2. Power off and unplug the QuantStudio

3D Instrument.

3. Turn the QuantStudio

3D Instrument over, then use your

fingers to carefully pry open the rear panel.

IMPORTANT! The rear panel is secured to the instrument

by three pegs that require significant force to decouple. If

necessary, insert a flathead screwdriver into the slot at the

base of the panel to pry it from the instrument chassis.

4. Turn the instrument over, then uncap the wireless dongle and

insert it into the USB port

within

the instrument. When the

device is seated within the USB port, firmly push on the

wireless dongle to ensure that it is plugged in completely.

The internal USB port is accessed through a small opening in

the instrument chassis.

5. Reattach the rear panel to the instrument chassis, then plug

in and power on the QuantStudio

3D Instrument.

From the Main Menu of the touchscreen, touch , then touch Instrument

Settings.

Connect the

QuantStudio

Instrument to a

network

Appendix B Networking

Connect the instrument to the network

QuantStudio

3D Digital PCR System User Guide