User guide

The Run History screen displays the data transfer status next to each file in the
instrument memory:
• Pass – The instrument successfully transferred the file to the selected
destination.
• In Progress – The instrument is either processing the imaging data for the
associated file, or transferring the file to the selected destination.
• Not exported – File transfer not attempted, or the selected destination is the
instrument (file transfer not required).
• Export Failed – The instrument was unable to transfer the file to the selected
destination.
• Run Failed – The instrument was unable to process the imaging data for the
chip.
5.
In the Results Details screen, touch Export, then touch Export again to transfer
the file to the USB drive.
6.
When finished, touch several times to return to the Main Menu, then remove
the USB drive from the instrument.
After exporting experiment (.eds) files to the USB drive, you can upload them to the
cloud for analysis using the QuantStudio
®
3D AnalysisSuite
™
Software.
Using the QuantStudio
®
3D AnalysisSuite
™
Software
After the analyzed imaging data has been transferred to the QuantStudio
®
3D
AnalysisSuite
™
Software, you can log into the software to perform the secondary
analysis as described below.
IMPORTANT! This section applies only to the cloud deployment of the QuantStudio
®
3D
AnalysisSuite
™
Software.
Chapter 4 Analyze the Prepared Chips
Using the QuantStudio
®
3D AnalysisSuite
™
Software
4
QuantStudio
®
3D Digital PCR System User Guide 77