User guide
Table Of Contents
- QuantStudio 3D Digital PCR System User Guide (Pub. no. MAN0007720 Rev. C.0)
- Copyright Page
- Contents
- About this guide
- Chapter 1. Getting Started
- About the QuantStudio® 3D Digital PCR System
- Operating the instrument
- Prepare the QuantStudio® 3D Digital PCR System for use
- Connect the QuantStudio® 3D Instrument to a network
- Connect the QuantStudio® 3D AnalysisSuite™ Software
- Chapter 2. Prepare Samples and Load Reactions
- Chapter 3. Perform the PCR
- Chapter 4. Analyze the Prepared Chips
- Chapter 5. Troubleshooting
- Appendix A. Maintenance
- Appendix B. Networking
- Appendix C. Parts and Materials
- Appendix D. Specifications and Layout
- Appendix E. Safety
- Documentation and support
- Back Cover
e.
Using the second cable tie, repeat steps a-d to secure the riser at the other
end of the foot.
d
b
c
45°
a
6.
Using scissors, remove the excess material from each cable tie.
4x
7.
Carefully roll the ProFlex
™
System back onto its feet.
ProFlex
PCR System
Chapter 1 Getting Started
Prepare the QuantStudio
®
3D Digital PCR System for use
1
26
QuantStudio
®
3D Digital PCR System User Guide