User guide
Table Of Contents
- QuantStudio 3D Digital PCR System User Guide (Pub. no. MAN0007720 Rev. C.0)
- Copyright Page
- Contents
- About this guide
- Chapter 1. Getting Started
- About the QuantStudio® 3D Digital PCR System
- Operating the instrument
- Prepare the QuantStudio® 3D Digital PCR System for use
- Connect the QuantStudio® 3D Instrument to a network
- Connect the QuantStudio® 3D AnalysisSuite™ Software
- Chapter 2. Prepare Samples and Load Reactions
- Chapter 3. Perform the PCR
- Chapter 4. Analyze the Prepared Chips
- Chapter 5. Troubleshooting
- Appendix A. Maintenance
- Appendix B. Networking
- Appendix C. Parts and Materials
- Appendix D. Specifications and Layout
- Appendix E. Safety
- Documentation and support
- Back Cover
e.
In the Network Complete screen, touch OK.
f.
In the Configuration screen, touch Edit to change the instrument settings.
g.
In the Edit Configuration screen, modify the fields as needed, then
touch Save.
•
Touch the Instrument Name field, enter up to a 16-character name for
the instrument, then touch
to save the setting.
IMPORTANT! The instrument name is an alphanumeric string used to
identify the QuantStudio
®
3D Instrument on the network. The
instrument name:
·
Can be up to 16 characters long.
·
Must consist of alphabetic and numeric characters.
·
Can contain hyphens, but not as the first or last characters in the
name.
·
Cannot include spaces or special characters ( ; : " < > * + = \ | ? , ).
Note: By default, the Instrument Name is set as the serial number of
the instrument.
•
Touch the Time Zone field, then select the correct continent and region
from the list.
• Touch the Date field, enter the current date, then touch Enter.
• Touch the Time field, enter the appropriate time units, then
touch Enter.
Chapter 1 Getting Started
Prepare the QuantStudio
®
3D Digital PCR System for use
1
22
QuantStudio
®
3D Digital PCR System User Guide