User guide
Table Of Contents
- QuantStudio 3D Digital PCR System User Guide (Pub. no. MAN0007720 Rev. C.0)
- Copyright Page
- Contents
- About this guide
- Chapter 1. Getting Started
- About the QuantStudio® 3D Digital PCR System
- Operating the instrument
- Prepare the QuantStudio® 3D Digital PCR System for use
- Connect the QuantStudio® 3D Instrument to a network
- Connect the QuantStudio® 3D AnalysisSuite™ Software
- Chapter 2. Prepare Samples and Load Reactions
- Chapter 3. Perform the PCR
- Chapter 4. Analyze the Prepared Chips
- Chapter 5. Troubleshooting
- Appendix A. Maintenance
- Appendix B. Networking
- Appendix C. Parts and Materials
- Appendix D. Specifications and Layout
- Appendix E. Safety
- Documentation and support
- Back Cover
d.
In the Choose Connection Type screen, select the appropriate connection:
Connection Action
Wired Touch LAN, then wait for the instrument to connect to
the network.
Wireless
1. Touch Wireless.
2. In the Available Wireless Network screen, touch the
desired wireless hotspot.
Note: The signal strength of a wireless hotspot is
indicated by the number of bars present in the
wireless icon ( ). The presence of a lock icon ( )
indicates that the hotspot is secure (WPA, WEP, or
WPA2).
3. If your selected wireless hotspot is secure, enter the
required authentication information (user name/
password), then touch OK.
None (no network
connection)
Offline to configure the instrument to save data to a
local USB drive.
The QuantStudio
®
3D Instrument is connected to the network when the
touchscreen displays the Network Complete screen.
Chapter 1 Getting Started
Prepare the QuantStudio
®
3D Digital PCR System for use
1
QuantStudio
®
3D Digital PCR System User Guide
21