User guide

Table Of Contents

Install the QuantStudio

3D Instrument:

Connect the power cord to the QuantStudio

3D Instrument, press the

power switch to the ON position, then wait for it to start (about 30 seconds).

The QuantStudio

3D Instrument is ready to configure when the

touchscreen displays the End User License Agreement.

IMPORTANT! If the QuantStudio

3D Instrument does not start, contact

customer support or your service representative for assistance.

In the End User License Agreement screen, touch Accept to accept the

agreement.

In the Network Connection screen, select the appropriate action:

IMPORTANT! The QuantStudio

3D Instrument is pre-configured for

DHCP network operation. If connecting your instrument to a network that

requires static IP assignment or advanced network configuration, touch

Skip Network Connection and connect your instrument to the network

following the installation.

• Touch Connect to Network to connect the QuantStudio

3D Instrument

to a wired or wireless network that supports DHCP. Go to the next step.

•

Touch Skip Network Connection if you do not want to connect to a

network, if you want to connect the instrument at a later time, or if your

network requires static IP assignment or advanced network settings. Go

to substep 1e.

Chapter 1 Getting Started

Prepare the QuantStudio

3D Digital PCR System for use

QuantStudio

3D Digital PCR System User Guide