User guide
Table Of Contents
- QuantStudio 3D Digital PCR System User Guide (Pub. no. MAN0007720 Rev. C.0)
- Copyright Page
- Contents
- About this guide
- Chapter 1. Getting Started
- About the QuantStudio® 3D Digital PCR System
- Operating the instrument
- Prepare the QuantStudio® 3D Digital PCR System for use
- Connect the QuantStudio® 3D Instrument to a network
- Connect the QuantStudio® 3D AnalysisSuite™ Software
- Chapter 2. Prepare Samples and Load Reactions
- Chapter 3. Perform the PCR
- Chapter 4. Analyze the Prepared Chips
- Chapter 5. Troubleshooting
- Appendix A. Maintenance
- Appendix B. Networking
- Appendix C. Parts and Materials
- Appendix D. Specifications and Layout
- Appendix E. Safety
- Documentation and support
- Back Cover
c.
Remove the QuantStudio
®
3D Instrument from the package and set it on a
clean level surface, then remove the protective cover.
d.
Inspect the QuantStudio
®
3D Instrument for damage caused during
transportation.
If the instrument is damaged, note the location and appearance of the
damage, then contact customer support or your service representative for
assistance.
Chapter 1 Getting Started
Prepare the QuantStudio
®
3D Digital PCR System for use
1
18
QuantStudio
®
3D Digital PCR System User Guide