User guide
Table Of Contents
- QuantStudio 3D Digital PCR System User Guide (Pub. no. MAN0007720 Rev. C.0)
- Copyright Page
- Contents
- About this guide
- Chapter 1. Getting Started
- About the QuantStudio® 3D Digital PCR System
- Operating the instrument
- Prepare the QuantStudio® 3D Digital PCR System for use
- Connect the QuantStudio® 3D Instrument to a network
- Connect the QuantStudio® 3D AnalysisSuite™ Software
- Chapter 2. Prepare Samples and Load Reactions
- Chapter 3. Perform the PCR
- Chapter 4. Analyze the Prepared Chips
- Chapter 5. Troubleshooting
- Appendix A. Maintenance
- Appendix B. Networking
- Appendix C. Parts and Materials
- Appendix D. Specifications and Layout
- Appendix E. Safety
- Documentation and support
- Back Cover
e.
Touch , then configure the Windows Internet Naming Service (WINS)
settings:
• Windows Domain – Enter the domain name of the WINS server.
• WINS Server – Enter the IP addresses for the primary (top) and
secondary (bottom) WINS servers.
IMPORTANT! WINS may be required if you specify a file server as a data
destination.
Note: During operation, the instrument attempts to resolve WINS names to
IP addresses using the server specified in the top-most field. If unavailable,
the instrument uses the server specified in the bottom-most field.
f.
When you are finished configuring your network settings, touch OK.
The touchscreen displays "Network Complete" when the instrument successfully
connects to the network.
Appendix B Networking
Connect the instrument to the network
B
102
QuantStudio
®
3D Digital PCR System User Guide